cgvsrtgbt

This Diagnostic Trouble Codes (DTC) is a generic code, which means that is applies to OBDII equipped vehicles including but not limited to Jeep Wrangler (JK), Grand Cherokee (WK), Cherokee (KL), Dodge (JC), Chrysler, Mercedes-Benz, BMW, Ford, VW, Chevrolet, Audi, Toyota, Honda, Hummer, Jaguar, Lexus, Volvo, Mazda, Mitsubishi, Nissan, Cadillac, GMC, Hyundai, Infiniti, Kia, Mini, etc.

Chronology of DTC P062C-ETC Level 2 MPH Performance

When Monitored P062C Code

This diagnostic runs when the following conditions are met :

Throttle motor is powered.
No vehicle speed related DTC have matured.

Set Conditions P062C Code

When secondary software determines that the vehicle speed is implausible for a period of time.

Default Action P062C Code

ETC Light will flash.

Possible Causes P062C Code

PCM needs to be programmed.
Powertrain Control Module (PCM.

Step by step DTC P062C-ETC Level 2 MPH Performance

Always perform the Pre-Diagnostic Troubleshooting procedure before proceeding.

Step 1. Program the Powertrain Control Module

Verify the PCM is at the latest calibration (flash level)

Note : An intermittent loose of power to the PCM without performing an ETC relearn procedure may cause this DTC to set.

If a PCM has later calibration available, program tha PCM in accordance with the service information.

Start the engine, allow the engine to idle. Operate the accelerator pedal (do not exceed 5300 rpm). With the scan tool, select view DTC.

Note : Diagnose any other DTC that may have set with the P062C.

Does this DTC reset by itself ?

Yes, replace and reprogram the Powertrain Control Module. Perform the Powertrain Verification Test.

No, test complete for DTC P062C-ETC Level 2 MPH Performance.